Bench bleeding MCPV-1

[rogertheracer]

Aaron, where should I adjust the front/rear bal. and pressure settings to bench blead?
manual disc/drum.
I will also be using the master cyl. bleeder kit, using full strokes at first,is this correct?

thanks again, Roger

ps , any other advice will be appreciated.

[CPPAaron]

Here is a link to the adjustment instructions. Classic Performance Products (http://www.classicperform.com/Instructions/PDF/MCPV1adjust.htm)

Last few I installed I did not touch the adjustment at all during the bench bleeding procedure and only fine tuned it after installed and bleed out.