Media Rep
04-22-2011, 03:35 AM
http://image.classictrucks.com/f/tech/1106clt_1959_chevy_apache_dash_install/36336792+ppromo_large/1106clt-01+1959-chevy-apache-dash-install+dashboard.jpg
The dash on my ’59 Chevy Apache always looked out of place with the Fleetside bed. I was brainstorming what I could do to set it apart or make it better match the truck’s exterior, when my good friend Jesse Barnes said he had a spare ’64 Chevy Nova dash that would match the lines of the bed better than the stock dash.
I knew this was no easy task and, to be honest, I was not sure if I was up for the challenge. I can MIG and TIG thicker-gauge material with no problem, but when it comes to the thinner dash-like material it is really easy to burn a hole right through the edges. I also wondered if the ’64 Nova dash would fit. I spent about a day trimming the edges and lining up the Nova dash to check if it would come close to fitting with minimal fabrication. After some more trimming and brainstorming I was confident that it would not look out of place; it was time to mark and cut the stock ’59 dash out. I know that the dash is not everyone’s cup of tea, but it should give the home customizer a chance to explore his or her options on what can be done with minimal tools and tons of planning. CT
More... (http://www.classictrucks.com/tech/1106clt_1959_chevy_apache_dash_install/index.html)
The dash on my ’59 Chevy Apache always looked out of place with the Fleetside bed. I was brainstorming what I could do to set it apart or make it better match the truck’s exterior, when my good friend Jesse Barnes said he had a spare ’64 Chevy Nova dash that would match the lines of the bed better than the stock dash.
I knew this was no easy task and, to be honest, I was not sure if I was up for the challenge. I can MIG and TIG thicker-gauge material with no problem, but when it comes to the thinner dash-like material it is really easy to burn a hole right through the edges. I also wondered if the ’64 Nova dash would fit. I spent about a day trimming the edges and lining up the Nova dash to check if it would come close to fitting with minimal fabrication. After some more trimming and brainstorming I was confident that it would not look out of place; it was time to mark and cut the stock ’59 dash out. I know that the dash is not everyone’s cup of tea, but it should give the home customizer a chance to explore his or her options on what can be done with minimal tools and tons of planning. CT
More... (http://www.classictrucks.com/tech/1106clt_1959_chevy_apache_dash_install/index.html)