PDA

View Full Version : CPP tilt column


tbucketnut
06-10-2011, 08:31 PM
I bought the 32" floor shift model ECSC-T and was thinking it will accept a 3/4DD inside the column reciever or a 1"DD outside the reciever end, am I correct??
CPPAaron
06-11-2011, 08:36 AM
Good Morning,

We only recommend using the outer 1" DD for coupling.
Roadmaster75
06-20-2011, 01:53 PM
Hi

I have wired up my #ECSC-S (33 incher) with turn sigs working, but have one wire left over....
It's the single black wire with the green blade connector. (Not part of the connector-ized turn signal group)
Can you confirm where it goes?
Thanks!
Roadmaster75
CPPAaron
06-20-2011, 02:39 PM
That is for the indicator light.
Roadmaster75
10-22-2011, 07:07 AM
Hi

I have wired up my #ECSC-S (33 incher) with turn sigs working, but have one wire left over....
It's the single black wire with the green blade connector. (Not part of the connector-ized turn signal group)
Can you confirm what it's for ; where it goes?
Thanks!
Roadmaster75