thanks aaron
i just installed some new 4 piston calipers on the front from gm metrics and will need to re-adjust my m/c.
roger
Type: Posts; User: rogertheracer; Keyword(s):
thanks aaron
i just installed some new 4 piston calipers on the front from gm metrics and will need to re-adjust my m/c.
roger
that means ill have max. pressure to the rear and max. balance to the front.
is this correct?
then check for natural brake balance by performing a full force stop.
then if need be, follow the...
arron: adj. procedure item #3 says:turn the large screw ccw untill it stops . (this is on the instruction sheet that came with the mc,ok)
now on the instruction sheet obtained from...
arron,
on adjusting the mcpv1,one instructions item #3 says adj .bal. rear clockwise until stop,
and on another instrution it says counter clockwise ???
on the instructions with the m/c it...
arron,
the pressure allen tuns easy ,but the balance allen turns hard, is this normal?
I use steel allen wrenches on both, the plastic one bends.
ps, i just turned them about 1/4-1/2 turn to see...
which valve is it that keeps the fluid on the rear drums ?
what if you lose the front brakes and the fluid leaks out ?
you would have no fluid for the rears , right ?
Aaron , why is there a hole in the lower half of divider inside the mcpv?
Wont that defeat the reason for the safety of the dual chamber?
Roger
Aaron,
Do I need any residual check valves when using my manual mcpv-1 (disk /drum) m/c ?
I assume with the adj. proportioning/metering valve I dont.
Please advise.
Instructions don't say either...
Aaron, where should I adjust the front/rear bal. and pressure settings to bench blead?
manual disc/drum.
I will also be using the master cyl. bleeder kit, using full strokes at first,is this...
Thanks for your quick reply Arron
Roger
Arron, is it ok to run 3/16" out of the rear of the mcpv-1( 1" bore disc/drum)
for a short distance (say 30") then go to 1/4" on back to the rear ?
Cuz I already have 1/4" going to the rear now.
...
Okidoki , thanks
Aaron, i just received my new m/c. (NICE)
Question: Im reading how to do the bleeding with the syringe (master in car)
Is this proceedure done with the brake lines connected to the master and the...
Aaron, I just received my MCPV1-C ( WOW IT IS NICE)
Question, I'm reading how to do the bleeding withe the syringe.(master in car)
Is this proceedure done with the brake line connected to the M/C...
aaron ,
in my first post (view) i indicated i had the heidts manual master cyl . 64 nova ( with gm calipers front and 9" ford drum rears . what improvement will i see by changing to the mcpv-1...
thanks aaron, is that a direct bolt on(no mods.) to my 64 nova (standard brakes) ?
i have a heidts front clip with 11" rotors/ 78-88 metric gm calipers and 9" ford rear drums.
which bore m/c do i need 1" or 1 1/8"? these are manual brakes.
its a 64 nova pro street with 31-18.5...