Results 1 to 8 of 8

Thread: Brake light switch

  1. #1

    Default Brake light switch

    Installed a power brake booster and front disc brakes. Need to know where to install the brake light switch on the booster/valve. Can I remove the brake warning switch and install there?

  2. #2

    Default

    The brake light warning on the proportional valve is only for a dash warning light. to install a fluid brake light switch you need to run a kit with a T and the switch like this:
    Hydraulic Brake Light Switch
    Aaron Strietzel
    Email Aaron
    Classic Performance Products Inc.
    378 E. Orangethorpe Ave
    Placentia, CA 92870
    Visit Our Site
    714/522-2000
    714/522-2500 fax

  3. #3

    Default

    Oh, The part number is 5356BLS-K
    Aaron Strietzel
    Email Aaron
    Classic Performance Products Inc.
    378 E. Orangethorpe Ave
    Placentia, CA 92870
    Visit Our Site
    714/522-2000
    714/522-2500 fax

  4. #4

    Default

    Can I use the switch off the original brake system. Also where do I plumb it in? There is a plug on the front of the valve, can I use it?

  5. #5

    Default

    The brake light switch will go in the rear line after it leaves the prop valve. The front spot cannot be used... Does not work correctly. The rear is the lower pressure.
    Aaron Strietzel
    Email Aaron
    Classic Performance Products Inc.
    378 E. Orangethorpe Ave
    Placentia, CA 92870
    Visit Our Site
    714/522-2000
    714/522-2500 fax

  6. #6

    Default Switch location

    Does it go before or after the Residual valve?
    Also what adapter would I need to connect my hard lines to the fittings in the kit? I had some couplings but they don't seem to fit right.

  7. #7

    Default

    before the residual valve. The fittings are a 3/16 or a 1/4" inverted flare. The residual should come with the correct adapter for either size.
    Aaron Strietzel
    Email Aaron
    Classic Performance Products Inc.
    378 E. Orangethorpe Ave
    Placentia, CA 92870
    Visit Our Site
    714/522-2000
    714/522-2500 fax

  8. #8
    Member
    Join Date
    Nov 2012
    Location
    USA, Chicago illinois
    Posts
    5

    Default

    The braking mechanism light change will go in the back line after it results in the brace device. The front identify cannot be used... Does not work effectively. The back is the lower stress.
    [url=http://surfersrentacar.com.au/]cheap car hire surfers paradise[/url]

Similar Threads

  1. Brake Warning light
    By myblue54 in forum Brakes
    Replies: 6
    Last Post: 11-23-2010, 07:07 AM
  2. Aftermarket Wiring Switch Installation - Up-Close Controls
    By Media Rep in forum Classic Trucks Tech Articles
    Replies: 0
    Last Post: 04-13-2010, 08:00 AM
  3. Aftermarket Wiring Switch Installation - Up-Close Controls
    By Media Rep in forum Classic Trucks Tech Articles
    Replies: 0
    Last Post: 03-30-2010, 02:27 PM
  4. Aftermarket Wiring Switch Installation - Up-Close Controls
    By Media Rep in forum Classic Trucks Tech Articles
    Replies: 0
    Last Post: 03-06-2010, 08:17 AM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •