PDA

View Full Version : Master Cylinder piston adjustment



Rodified
04-28-2014, 04:37 AM
I have a Kugal Komponents thru the firewall brake pedal assembly. I have a CPP Corvette type 1 inch bore mastercylinder with the fancy proportioning valve and bracket under it. My question is how do I know where to adjust the piston that goes into the master cylinder? Do I adjust it to where it pushes into the master cylinder until it stops or what is the rule of thumb? Thanks!!

CPPAaron
04-28-2014, 06:36 AM
what you need is to have a 1/32"-1/16" of freeplay between the two. This will ensure that you dont have a pre-load situation.

Rodified
04-30-2014, 09:26 AM
I have a Kugal Komponents thru the firewall brake pedal assembly. I have a CPP Corvette type 1 inch bore mastercylinder with the fancy proportioning valve and bracket under it. My question is how do I know where to adjust the piston that goes into the master cylinder? Do I adjust it to where it pushes into the master cylinder until it stops or what is the rule of thumb? Thanks!!


Thanks Aaron

Byydhelo
05-21-2015, 06:33 AM
Very good and informative exchange .. Thank you!